Xerox 1186 User Manual page 106

OIAG NOSTles
Pilot
Operating System Codes
0900·0999
Lisp Codes
9000-9299
92
Pilot Operating System codes are described below:
Pilot Error Codes
0915
Pilot breakpoint:
ean signify any number of problems, such
as: bad page on the rigid disk, cannot read
the floppy disk, or a hardware failure. To
recover, try running ALAG. If ALAG passes
and its Media Scan test shows no new bad
pages, the floppy disk (software
installation) is suspect.
0937 Trying to find out the time and date:
Trying to get the time off the Ethernet. If it
hangs here the software was incorrectly
installed. Time can be set from within Lisp
(with SETIIME). Standalone users take
note: you must set the time everytime you
boot Lisp. .
0981 Trying to discover Ethernet PUP host
number:
Will hang in this state if non-Lisp code tries
to perform PUP operations and no PUP 10
Server responds, or processor 10 is not
registered. See system administrator.
Interlisp-D Microcode Error Codes
Most of these errors are indicative of some serious
problem; Lisp software attempts to cause regular
breaks when these occu r.
9001
CSParErr
Control store parity error;
a hardware error
XEROX
1186
USER'S GUIDE