Xerox 1186 User Manual page 130

APPENDIX 8
8-2
Select Choice 1. The menu will be expanded and
present you with four options:
1 •
Read Master
2· Make Copy
3 • Calculate Checksum
4· Quit
To make a copy, select choice 1. You will be
prompted to insert the source floppy into the
floppy drive. When the source floppy has been read
into the machine, a short beep will occur. You
should then select choice 2 to write out the image
retained in the machine onto the destination
floppy. You will be prompted to insert the
destination floppy into the floppy drive.
You may calculate the checksum of any floppy by
selecting choice 3 from the menu. This value is
useful when compared with the checksum of a
copied floppy, because each copy should have the
same checksum value
as
the original. If the
checksums differ, you can assume something is
wrong with the copied floppy diskette.
When you wish to exit the Floppy Disk Copy Utility,
select choice 4· Quit, to return to the menu entitled
Floppy Duplication and Verification Facility; from
here select choice 2· Go To Previous Menu. You will
be asked to confirm this choice:
Test data
will
be deleted upon exit. Is this
OK?
Answer Y to exit.
XEROX 1186 USER'S GUIDE