Ethernet Transceiver And Controller; Ethernet Interface; Peripheral Equipment; Cables - Xerox 1186 User Manual

EQUIPMENT
Ethernet Transceiver and Controller
The Ethernet transceiver and controller are used to
connect workstations to the Ethernet, a high-speed
(10 million bits per second) communications link
used by Xerox.
Ethernet Interface
The Ethernet interface supports both the Ethernet
specification, Version 1.0, and the IEEE802.3
standard. The physical network hardware can be
any standard coaxial cable that fully meets
Ethernet's specification, or an RG58 cable Per IEEE
802.3 1985 (ISO DIS 88022/3). The drop cable
connector can accept either the Ethernet version 1.0
or IEEE 802.3 drop cables. The transfer rate using
this interface is 10 megabits per second.
Peripheral Equipment
Cables
24
The following peripheral equipment is required to
configure your 1186 workstation.
A standard 1186 configuration uses the following
five cables:
•
workstation power cord
•
display power cord
•
display signal cable
•
keyboard cable
•
mouse cable
XEROX 1186 USER'S GUIDE