Troubleshooting - Xerox 1186 User Manual

USING THE 1186
Trou
blesh
ooting
This section describes some of the more common
problems that may occur when you are using your
1186 workstation.
Problem: The display is black, with no bouncing
white rectangle.
1. Check the intensity wheel to see if it is turned all
the way up. (The intensity thumbwheel is
located just behind the display screen, on the
right-hand side.)
2. Make sure the processor is plugged in.
3. Make sure the processor is turned on.
Problem: The cursor will not move.
1. Test the mouse's sensors by moving it in circles
on the plastic pad.
2. Make sure the two-button mouse is on the
special plastic pad or other non-slip surface. The
three-button mouse must be on its special
optical paper (grey-colored with small,
hexagonal pattern.)
3. Make sure the thin cable is attached securely to
the mouse and the keyboard.
4. Check the cursor code that is displayed on your
display screen. If the code is a number other
than 1186, write the code down and report it to
your system administrator, or the Xerox service
representative.
XEROX 1186 USER'SGUIDE
31