Kohler Comand Pro CH1000 Service Manual page 86

Section 8
Disassembly
Remove Oil Cooler
1. Remove the two oil cooler mounting screws. Do
not lose any washers (if used). See Figure 8-19.
Figure 8-19. Removing Oil Cooler Mounting
Screws.
2. Loosen the clamps and disconnect each of the
hoses from the oil cooler. See Figure 8-20.
NOTE: New clamps are recommended any time
disassembly is performed, or if clamps have
been loosened (expanded) several times.
Figure 8-20. Disconnecting Hoses From Oil Cooler.
Remove Oil Filter Housing and Oil Filter
Adapter
1. Remove the screw securing the oil fi lter housing
and individual O-rings to the adapter. Carefully
separate the parts. See Figure 8-21.
NOTE: Further disassembly of the oil fi lter housing
assembly is not required unless individual
servicing must be performed. Follow
substeps a, b, and c.
8.6
Housing Housing
Mounting Mounting
Screw Screw
Figure 8-21. Removing Oil Filter Housing From
Adapter.
Perform the following only if the oil fi lter housing
assembly requires individual servicing.
a. Remove the nipple from the cup and oil fi lter
housing. See Figure 8-22.
Nipple
Figure 8-22. Removing Nipple.
b. Remove the oil fi lter cup and spring from
housing. See Figure 8-23.
Housing
Spring
Figure 8-23. Disassembled Cup and Spring.
c. Remove the rubber valve and spring from
the cup. See Figure 8-24.
Cup
Nipple