Kohler Comand Pro CH1000 Service Manual page 131

Install Outer Cylinder Baffl es
1. Install the outer cylinder baffl es. Make sure
the spark plug lead is routed through the
corresponding opening in each baffl e. Start each
of the screws. Torque the M6 shoulder screws
going through the backing shroud assembly
into the extruded holes in the baffl es to 4.0 N·m
(35 in. lb.) for fi rst time installations, or 2.0 N·m
(18 in. lb.) for all reinstallations.
Torque the M6 screws going into the cylinder
head and crankcase to 10.7 N·m (95 in. lb.) for
new holes, or 7.3 N·m (65 in. lb.) for used holes.
See Figure 10-84.
Cylinder
Baffl e
Mounting Mounting
Screws Screws
Mounting
Screws
Figure 10-84. Installing Cylinder Baffl es.
Install Oil Cooler
1. Connect the two hoses between the oil fi lter
adapter and oil cooler. Secure with new clamps.
See Figure 10-85.
Hoses
Figure 10-85. Connecting Oil Cooler Hoses.
2. Align the oil cooler with the bosses in the backing
shroud assembly. Secure with the two screws and
washers. See Figure 10-86.
Mounting Screws
Figure 10-86. Installing Oil Cooler.
Section 10
Reassembly
10
10.21