Kohler Comand Pro CH1000 Service Manual page 134

Section 10
Reassembly
Install Control Bracket and Air Cleaner
Assembly
1. Position the control bracket assembly onto
the two intake manifold bosses. Align the rear
supports with the top valley baffl e/cylinder head
mounting screw locations and install the two
screws, but do not fully tighten. See Figure 10-94.
Control Bracket
Rear Mounting
Locations
Figure 10-94. Installing Control Bracket.
2. Connect the choke link to the control pivot pin.
Reinstall the washer and secure with a new push-
on pal nut. See Figure 10-95.
Push-On Nut
Figure 10-95. Installing Choke Link and Push-On
Nut.
3. Install a new air cleaner elbow gasket onto the
carburetor mounting studs.
10.24
Washer
Choke Link
4. Slide the air cleaner assembly onto the four
carburetor mounting studs. Align the two
forward mounting holes in the base with the
mounting holes/bosses of the intake manifold
and control bracket. Att ach the ground lead
under the hex nut as originally installed. Install
the remaining three hex nuts and start the two
hex fl ange screws. Install the rear mounting
screws into the valley baffl e/cylinder head. Check
the positions of all parts then torque the four hex
fl ange nuts to 7.9 N·m (70 in. lb.) in the sequence
shown (Figure 10-98), and the four hex fl ange
screws to 9.9 N·m (88 in. lb.). See Figures 10-96,
10-97, and 10-98.
NOTE: The low-profi le air cleaner is installed the
same way as the heavy-duty air cleaner.
Ground Lead
Breather Hose
Figure 10-96. Mounting Air Cleaner and Hoses.
Mounting Screws
Figure 10-97. Installing Air Cleaner and Control
Bracket Screws.
Vent Hose
Mounting Nuts