Kohler Comand Pro CH1000 Service Manual page 133

Valley Baffl e
Figure 10-90. Installing Valley Baffl es.
Install Carburetor
WARNING: Explosive Fuel!
Gasoline may be present in the carburetor and fuel system.
Gasoline is extremely fl ammable and its vapors can explode
if ignited. Keep sparks and other sources of ignition away
from the engine.
1. Install a new carburetor gasket onto the intake
manifold with the tab up. Make sure all holes
align and are open.
2. Att ach the choke return spring and bracket to the
front hole in the choke lever on carburetor. See
Figure 10-91.
Choke Choke
Lever Lever
Choke Return Spring and Bracket Choke Return Spring and Bracket
Figure 10-91. Choke Return Spring and Bracket
Details.
3. Connect the thrott le and choke linkages to the
carburetor if they were previously disconnected.
Install the carburetor with the linkages att ached
as an assembly. See Figure 10-92.
Gasket
(Tab Up)
Choke Choke
Linkage Linkage
Figure 10-92. Installing Carburetor with Linkages.
4. Connect the fuel line to the carburetor inlet and
secure with a clamp.
Install Governor Lever
1. Install the governor lever onto the governor shaft
and connect the thrott le linkage with the black
clip. Do not tighten the governor lever at this
time. See Figure 10-93.
Throttle Linkage
and Black Clip
Figure 10-93. Installing Governor Lever.
Section 10
Reassembly
Carburetor Carburetor
Throttle Throttle
Linkage Linkage
Governor
Lever
10
10.23