Kohler Comand Pro CH1000 Service Manual page 20

Section 2
Tools & Aids
Tools (cont.)
Description
Flywheel Strap Wrench
To hold fl ywheel during removal.
Hydraulic Valve Lift er Tool
To remove and install hydraulic lift ers.
Ignition System Tester
For testing output on all systems, except CD.
For testing output on capacitive discharge (CD) ignition system.
Off set Wrench (K & M Series)
To remove and reinstall cylinder barrel retaining nuts.
Oil Pressure Test Kit
To test and verify oil pressure.
Rectifi er-Regulator Tester (120 volt current)
Rectifi er-Regulator Tester (240 volt current)
Used to test rectifi er-regulators.
Individual Components Available
CS-PRO Regulator Test Harness
Special Regulator Test Harness with Diode
Spark Advance Module (SAM) Tester
To test the SAM (ASAM and DSAM) on engines with SMART-SPARK
Starter Brush Holding Tool (Solenoid Shift )
To hold brushes during servicing.
Starter Retaining Ring Tool (Inertia Drive)
To remove and reinstall drive retaining rings (excluding FASCO starters).
Starter Servicing Kit (All Starters)
To remove and reinstall drive retaining rings and brushes.
Individual Component Available
Starter Brush Holding Tool (Solenoid Shift )
Tachometer (Digital Inductive)
For checking operating speed (RPM) of an engine.
Vacuum/Pressure Tester
Alternative to a water manometer.
Valve Guide Reamer (K & M Series)
For sizing valve guides aft er installation.
2.2
Source/Part No.
SE Tools KLR-82409
Kohler 25 761 38-S
Kohler 25 455 01-S
Kohler 24 455 02-S
SE Tools KLR-82410
Kohler 25 761 06-S
Kohler 25 761 20-S
Kohler 25 761 41-S
Design Technology Inc.
Kohler 25 761 40-S
™.
SE Tools KLR-82416
Kohler 25 761 18-S
SE Tools KLR-82411
SE Tools KLR-82416
Design Technology Inc.
Kohler 25 761 22-S
SE Tools KLR-82413
DTI-031
DTI-033
DTI-110