Kohler Comand Pro CH1000 Service Manual page 136

Section 10
Reassembly
2. Move the governor lever toward the carburetor as
far as it will go (wide-open thrott le) and hold in
position. See Figure 10-102.
3. Insert a long thin rod or tool into the hole on the
cross shaft and rotate the shaft clockwise (viewed
from the end) as far as it will turn, then torque
the hex nut to 7.3 N·m (65 in. lb.). See Figure 10-
102.
Move and Move and
Hold Hold
Towards Towards
Carburetor Carburetor
Figure 10-102. Adjusting Governor.
4. Ensure that the correct color springs are used.
Connect the governor spring (with long looped
end), to the inner hole on the governor lever and
control bracket.
Connect the governed idle spring to the outer
governor lever hole and control bracket. The long
end of each spring must be toward the governor
lever. Make sure the springs do not contact the
valley baffl e. See Figure 10-103.
Figure 10-103. Governor Springs Installed.
10.26
Lift/Rotate Lift/Rotate
Clockwise Clockwise
Governed Idle Governed Idle
Spring Spring
Governor Spring Governor Spring
Governor Spring/RPM Chart
CH940-CH1000
Governor Idle Spring
(Color)
Clear
Black
CH940, CH960, CH980
Governor Spring
(Color)
Red
Green
Green Patch
Red Patch
CH1000
Governor Spring
(Color)
Yellow Patch
Purple Patch
Purple
Figure 10-104. Governor Spring/RPM Chart.
Mounted Control Bracket
Figure 10-105. Control Bracket Assembly on
Engine.
Install Oil Sentry™ (If Equipped)
1. Apply pipe sealant with Tefl on
PST ® Thread Sealant or equivalent) to the threads
of the Oil Sentry™ switch and install it into the
1/8 in. port in the closure plate. See Figure 10-106.
Torque the switch to 10.1 N·m (90 in. lb.).
High Speed (RPM)
1400-1625 RPM
1626-1800 RPM
High Speed (RPM)
3000-3150 RPM
3151-3300 RPM
3301-3675 RPM
3676-3900 RPM
High Speed (RPM)
3000-3150 RPM
3151-3450 RPM
3451-3900 RPM
® (Loctite ® 592™