Kohler Comand Pro CH1000 Service Manual page 85

5. The carburetor and linkages can be separated as
necessary.
Remove Oil Sentry™ (If Equipped)
1. Disconnect the lead from the Oil Sentry™ switch.
2. Remove the Oil Sentry™ switch from the closure
plate. See Figure 8-15.
Figure 8-15. Oil Sentry™ Switch Location in
Closure Plate.
Remove Baffl es and Intake Manifold
1. Remove the screws securing the valley baffl es to
the cylinder heads and backing shroud assembly.
Figure 8-16. Removing Valley Baffl es.
2. Remove the four screws securing each of the
outer cylinder baffl es in place. Two of the screws
are accessed from the backing shroud side. See
Figure 8-17.
Mounting
Screws
Figure 8-17. Removing Outer Cylinder Baffl es.
Pressure Pressure
3. Remove the four hex fl ange screws securing the
Switch Switch
4. Remove the intake manifold and gaskets. See
Figure 8-18. Removing Intake Manifold.
intake manifold to the cylinder heads. Cut any
wire ties that secure the wiring harness or leads
to the intake manifold.
Figure 8-18.
Mounting
Locations
Section 8
Disassembly
Mounting
Locations
8
8.5