Kohler Comand Pro CH1000 Service Manual page 127

4. Install the nipple in housing and torque to
18.0 N·m (159 in. lb.). See Figures 10-67 and
10-68.
Figure 10-67. Installing Nipple.
Figure 10-68. Torquing Nipple.
Installation
1. Make sure all sealing surfaces are clean and all
three dowel pins are in position. Install or check
that new O-rings are around all three dowel pins
of the oil fi lter adapter. See Figure 10-69.
Figure 10-69. O-rings Installed on Adapter for Oil
Filter Housing.
Nipple
Figure 10-70. Installing Oil Filter Housing.
Install Backing Shroud Assembly
O-rings O-rings
Figure 10-71. Lower Oil Cooler Hose Details.
NOTE: New hose clamps are recommended for
2. Install the oil fi lter housing assembly to the
adapter and secure with the M8 hex head screw.
Make sure the housing is fl at on the crankcase
and all O-rings remain in position. Torque the
screw to 24.4 N·m (216 in. lb.).
Mounting
Screw
3. The oil fi lter may be installed now or upon
completion of engine assembly, as described in
Section 6.
1. To aid assembly, install the lower oil cooler hose
onto the oil fi lter housing prior to installation of
the backing shroud assembly, and secure with a
clamp. See Figure 10-71.
reassembly, or if clamps have been loosened
(expanded) several times to avoid leakage.
Section 10
Reassembly
Oil Filter Housing
10
10.17