Kohler Comand Pro CH1000 Service Manual page 113

Main
Bearing
Figure 10-6. Installed Main Bearing.
Install Governor Shafts, Seal, and
Governor Gear
If the governor shaft s, seal, and/or governor gear were
removed, reassemble as follows.
1. Lightly oil the lip and outside diameter of the
new governor cross shaft seal. Install the seal into
the crankcase to the depth shown in Figure 10-8.
Figure 10-7. Installing Governor Cross Shaft Seal.
Seal depth
1.5-2.0 mm (0.059-0.078 in.)
Crankcase
Surface
Oil Seal
Figure 10-8. Governor Shaft Seal Depth.
Notch
Seal
2. If the governor gear shaft was removed, press or
lightly tap the replacement shaft into the closure
plate to depth shown in Figure 10-10.
Governor
Gear Shaft
Figure 10-9. Installed Governor Gear Shaft.
12.66 mm
(0.498 in.)
Crankcase
Surface
Figure 10-10. Governor Gear Shaft Press Depth.
3. Lubricate the governor cross shaft bearing
surfaces in the crankcase with engine oil. Insert
the end with the fl at for the governor gear yoke
into the crankcase fi rst and position so the fl at is
up. See Figure 10-11.
Governor Governor
Cross Shaft Cross Shaft
Figure 10-11. Installing Governor Cross Shaft.
Section 10
Reassembly
Governor
Gear Shaft
10
10.3