Lock Lever (Unload Lever); Working Light Switch; Beacon Light Switch - Kubota KX 016-4 Operator's Manual

18 EXCAVATOR OPERATION
3. After starting the engine, bring the lock
lever (unload lever) into the "Unlock"
position to use drive lever or control
lever for front attachments.
BLock Lever (Unload Lever)
To avoid personal injury:
A To avoid injuries, check safety features all
around the excavator.
A With the lock lever (unload lever) pulled down, the
engine fails to start.
If you try to start the engine with the key with the lock lever
(unload lever) down, the "
flashing.

(1) Lock lever (Unload lever)

" lamp (yellow) starts
(A) "Unlock"
(B) "Lock"
BWorking Light Switch
When the starter switch is in position "RUN", the light(s)
will be switched on by pressing the switch.

(1) Working light switch

C Night operation
To avoid personal injury:
A Visibility is reduced in darkness, therefore the
work light alone may not be enough. In which
case, prepare additional stationary artificial
lighting, observe safety rules as well as special
regulations for night work.
BBeacon Light Switch
It is equipped only with the switch (including the coupler
for connecting in a rear left speaker).
Since it isn't equipped with the beacon main part, please
post - install, when required.

(1) Beacon light switch