Kubota KX 016-4 Operator's Manual page 85

LED Display
Clock setting request
9
---
10
Raise the control lever
lock
11
Pull out the key
12
Lower the control lever
lock
13
Oil pressure too low
14
Overheat
15
Charging system error
16
LED Problem / Error
Power was interrupted
and the clock now has
to be set again.
--- ---
This
indicates a step in a
(yellow) procedure.
The key must
pulled out.
This
indicates a step in a
(yellow) procedure.
(red) The engine
+ pressure is too low.
The machine
overheated and must
cool off by idling.
(red) The charging system
+ has developed a fault.
TROUBLESHOOTING
Solution #1
In order to set the
clock, press the user
setting switch.
---
message Raise the lock lever
(unload lever); the
indicator goes out.
be
Pull out the key.
message Lower the lock lever
(unload lever); the
indicator goes out.
Stop the
oil immediately.
engine may have
developed a fault.
Allow the machine to
cool off by idling. Do
is
not switch
engine off as the
coolant could then
boil over.
Check the V-belt.
When the V-belt is
OK, let the engine
run until the indicator
goes out.
Solution #2
---
---
---
---
---
engine
Inform your
The
KUBOTA dealer
immediately.
Clean the radiator
and check the
coolant. Refill the
radiator with
coolant by
boiled-over
amount. Unclog
the radiator and
other components
the
before use again.
Check also the
hydraulic system
for oil leak and
other troubles.
If an oil leak is
found,
immediately
contact your local
dealer for repair.
If the indicator
does not go out,
inform your
KUBOTA dealer
immediately.
63
its