Enabling And Configuring Port Security Aging - Cisco IE 3000 Software Configuration Manual

Chapter 22 Configuring Port-Based Traffic Control
Switch(config-if)# switchport port-security mac-address 0000.0000.0003
Switch(config-if)# switchport port-security mac-address sticky 0000.0000.0001 vlan voice
Switch(config-if)# switchport port-security mac-address 0000.0000.0004 vlan voice
Switch(config-if)# switchport port-security maximum 10 vlan access
Switch(config-if)# switchport port-security maximum 10 vlan voice

Enabling and Configuring Port Security Aging

You can use port security aging to set the aging time for all secure addresses on a port. Two types of
aging are supported per port:
•
•
Use this feature to remove and add devices on a secure port without manually deleting the existing secure
MAC addresses and to still limit the number of secure addresses on a port. You can enable or disable the
aging of secure addresses on a per-port basis.
Beginning in privileged EXEC mode, follow these steps to configure port security aging:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3 switchport port-security aging {static | time time |
type {absolute | inactivity}}
Step 4 end
Step 5
show port-security [interface interface-id]
[address]
Step 6
copy running-config startup-config
OL-13018-01
Absolute—The secure addresses on the port are deleted after the specified aging time.
Inactivity—The secure addresses on the port are deleted only if the secure addresses are inactive for
the specified aging time.
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface
configuration mode.
Enable or disable static aging for the secure port, or set the
aging time or type.
The switch does not support port security aging of
Note
sticky secure addresses.
Enter static to enable aging for statically configured secure
addresses on this port.
For time, specify the aging time for this port. The valid range is
from 0 to 1440 minutes.
For type, select one of these keywords:
absolute—Sets the aging type as absolute aging. All the
•
secure addresses on this port age out exactly after the time
(minutes) specified lapses and are removed from the secure
address list.
• inactivity—Sets the aging type as inactivity aging. The
secure addresses on this port age out only if there is no data
traffic from the secure source addresses for the specified
time period.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco IE 3000 Switch Software Configuration Guide
Configuring Port Security
22-17