Configuring Ingress Queue Characteristics - Cisco IE 3000 Software Configuration Manual

Chapter 32 Configuring QoS
Command
Step 4
mls qos trust dscp
Step 5
mls qos dscp-mutation
dscp-mutation-name
Step 6
end
Step 7 show mls qos maps dscp-mutation
Step 8 copy running-config startup-config
To return to the default map, use the no mls qos dscp-mutation dscp-mutation-name global
configuration command.
This example shows how to define the DSCP-to-DSCP-mutation map. All the entries that are not
explicitly configured are not modified (remains as specified in the null map):
Switch(config)# mls qos map dscp-mutation mutation1 1 2 3 4 5 6 7 to 0
Switch(config)# mls qos map dscp-mutation mutation1 8 9 10 11 12 13 to 10
Switch(config)# mls qos map dscp-mutation mutation1 20 21 22 to 20
Switch(config)# mls qos map dscp-mutation mutation1 30 31 32 33 34 to 30
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# mls qos trust dscp
Switch(config-if)# mls qos dscp-mutation mutation1
Switch(config-if)# end
Switch# show mls qos maps dscp-mutation mutation1
Dscp-dscp mutation map:
mutation1:
In the above DSCP-to-DSCP-mutation map, the mutated values are shown in the body of the matrix. The
Note
d1 column specifies the most-significant digit of the original DSCP; the d2 row specifies the
least-significant digit of the original DSCP. The intersection of the d1 and d2 values provides the mutated
value. For example, a DSCP value of 12 corresponds to a mutated value of 10.

Configuring Ingress Queue Characteristics

Depending on the complexity of your network and your QoS solution, you might need to perform all of
the tasks in the next sections. You will need to make decisions about these characteristics:
•
•
•
OL-13018-01
d1 : d2 0 1 2 3 4
---------------------------------------
0 : 00 00 00 00 00 00 00 00 10 10
1 : 10 10 10 10 14 15 16 17 18 19
2 : 20 20 20 23 24 25 26 27 28 29
3 : 30 30 30 30 30 35 36 37 38 39
4 : 40 41 42 43 44 45 46 47 48 49
5 : 50 51 52 53 54 55 56 57 58 59
6 : 60 61 62 63
Which packets are assigned (by DSCP or CoS value) to each queue?
What drop percentage thresholds apply to each queue, and which CoS or DSCP values map to each
threshold?
How much of the available buffer space is allocated between the queues?
Purpose
Configure the ingress port as a DSCP-trusted port. By default, the port
is not trusted.
Apply the map to the specified ingress DSCP-trusted port.
For dscp-mutation-name, enter the mutation map name specified in
Step 2.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
5 6 7 8 9
Cisco IE 3000 Switch Software Configuration Guide
Configuring Standard QoS
32-55