Enabling Vtp Version 2 - Cisco IE 3000 Software Configuration Manual

Chapter 14 Configuring VTP

Enabling VTP Version 2

VTP Version 2 is disabled by default on VTP Version 2-capable switches. When you enable VTP
Version 2 on a switch, every VTP Version 2-capable switch in the VTP domain enables Version 2. You
can only configure the version when the switches are in VTP server or transparent mode.
VTP Version 1 and VTP Version 2 are not interoperable on switches in the same VTP domain. Every
Caution
switch in the VTP domain must use the same VTP version. Do not enable VTP Version 2 unless every
switch in the VTP domain supports Version 2.
In TrCRF and TrBRF Token ring environments, you must enable VTP Version 2 for Token Ring VLAN
Note
switching to function properly. For Token Ring and Token Ring-Net media, VTP Version 2 must be
disabled.
For more information on VTP version configuration guidelines, see the
page
Beginning in privileged EXEC mode, follow these steps to enable VTP Version 2:
Command
Step 1 configure terminal
Step 2 vtp version 2
Step 3
end
Step 4 show vtp status
To disable VTP Version 2, use the no vtp version global configuration command.
You can also enable VTP Version 2 by using the vlan database privileged EXEC command to enter
Note
VLAN database configuration mode and by entering the vtp v2-mode VLAN database configuration
command. To disable VTP Version 2, use the no vtp v2-mode VLAN database configuration command.
OL-13018-01
14-8.
Purpose
Enter global configuration mode.
Enable VTP Version 2 on the switch.
VTP Version 2 is disabled by default on VTP Version 2-capable switches.
Return to privileged EXEC mode.
In the VTP V2 Mode field of the display, verify that VTP Version 2 is enabled.
"VTP Version" section on
Cisco IE 3000 Switch Software Configuration Guide
Configuring VTP
14-13