Automatic Recovery Of Cluster Configuration - Cisco IE 3000 Software Configuration Manual

Chapter 6 Clustering Switches
•
Figure 6-6
Management

Automatic Recovery of Cluster Configuration

The active cluster command switch continually forwards cluster-configuration information (but not
device-configuration information) to the standby cluster command switch. This ensures that the standby
cluster command switch can take over the cluster immediately after the active cluster command switch
fails.
Automatic discovery has these limitations:
•
OL-13018-01
Each standby-group member
the same VLAN. In this example, the cluster command switch and standby cluster command
switches are Catalyst 2970, Catalyst 3550, Catalyst 3560, or Catalyst 3750 cluster command
switches. Each standby-group member must also be redundantly connected to each other through at
least one VLAN in common with the switch cluster.
Catalyst 1900, Catalyst 2820, Catalyst 2900 XL, Catalyst 2950, and Catalyst 3500 XL cluster
member switches must be connected to the cluster standby group through their management
VLANs. For more information about VLANs in switch clusters, see these sections:
"Discovery Through Different VLANs" section on page 6-6
–
"Discovery Through Different Management VLANs" section on page 6-7
–
VLAN Connectivity between Standby-Group Members and Cluster Members
Command
device
VLANs 9,16
VLAN 9
VLAN 9
VLAN 9
This limitation applies only to clusters that have Catalyst 2950, Catalyst 3550, Catalyst 3560, and
Catalyst 3750 command and standby cluster command switches: If the active cluster command
switch and standby cluster command switch become disabled at the same time, the passive cluster
command switch with the highest priority becomes the active cluster command switch. However,
because it was a passive standby cluster command switch, the previous cluster command switch did
not forward cluster-configuration information to it. The active cluster command switch only
forwards cluster-configuration information to the standby cluster command switch. You must
therefore rebuild the cluster.
(Figure 6-6) must be connected to the cluster command switch through
Passive
command device
VLANs 9,16
Management
VLAN 16
Member devices
Cisco IE 3000 Switch Software Configuration Guide
Planning a Switch Cluster
Standby
command device
Management
VLAN 16
VLAN 16
6-11