Configuring Snmp Groups And Users - Cisco IE 3000 Software Configuration Manual

Chapter 29 Configuring SNMP
Command
Step 3
access-list access-list-number {deny |
permit} source [source-wildcard]
Step 4 end
Step 5
show running-config
Step 6 copy running-config startup-config
To disable access for an SNMP community, set the community string for that community to the null
Note
string (do not enter a value for the community string).
To remove a specific community string, use the no snmp-server community string global configuration
command.
This example shows how to assign the string comaccess to SNMP, to allow read-only access, and to
specify that IP access list 4 can use the community string to gain access to the switch SNMP agent:
Switch(config)# snmp-server community comaccess ro 4

Configuring SNMP Groups and Users

You can specify an identification name (engine ID) for the local or remote SNMP server engine on the
switch. You can configure an SNMP server group that maps SNMP users to SNMP views, and you can
add new users to the SNMP group.
OL-13018-01
Purpose
(Optional) If you specified an IP standard access list number in
Step 2, then create the list, repeating the command as many times
as necessary.
For access-list-number, enter the access list number specified
•
in Step 2.
The deny keyword denies access if the conditions are
•
matched. The permit keyword permits access if the conditions
are matched.
For source, enter the IP address of the SNMP managers that
•
are permitted to use the community string to gain access to the
agent.
• (Optional) For source-wildcard, enter the wildcard bits in
dotted decimal notation to be applied to the source. Place ones
in the bit positions that you want to ignore.
Recall that the access list is always terminated by an implicit deny
statement for everything.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco IE 3000 Switch Software Configuration Guide
Configuring SNMP
29-9