Configuring Radius Authorization For User Privileged Access And Network Services - Cisco IE 3000 Software Configuration Manual

Chapter 9 Configuring Switch-Based Authentication
Command
Step 8
copy running-config startup-config
Step 9
To remove the specified RADIUS server, use the no radius-server host hostname | ip-address global
configuration command. To remove a server group from the configuration list, use the no aaa group
server radius group-name global configuration command. To remove the IP address of a RADIUS
server, use the no server ip-address server group configuration command.
In this example, the switch is configured to recognize two different RADIUS group servers (group1 and
group2). Group1 has two different host entries on the same RADIUS server configured for the same
services. The second host entry acts as a fail-over backup to the first entry.
Switch(config)# radius-server host 172.20.0.1 auth-port 1000 acct-port 1001
Switch(config)# radius-server host 172.10.0.1 auth-port 1645 acct-port 1646
Switch(config)# aaa new-model
Switch(config)# aaa group server radius group1
Switch(config-sg-radius)# server 172.20.0.1 auth-port 1000 acct-port 1001
Switch(config-sg-radius)# exit
Switch(config)# aaa group server radius group2
Switch(config-sg-radius)# server 172.20.0.1 auth-port 2000 acct-port 2001
Switch(config-sg-radius)# exit

Configuring RADIUS Authorization for User Privileged Access and Network Services

AAA authorization limits the services available to a user. When AAA authorization is enabled, the
switch uses information retrieved from the user's profile, which is in the local user database or on the
security server, to configure the user's session. The user is granted access to a requested service only if
the information in the user profile allows it.
You can use the aaa authorization global configuration command with the radius keyword to set
parameters that restrict a user's network access to privileged EXEC mode.
The aaa authorization exec radius local command sets these authorization parameters:
•
•
Authorization is bypassed for authenticated users who log in through the CLI even if authorization has
Note
been configured.
Beginning in privileged EXEC mode, follow these steps to specify RADIUS authorization for privileged
EXEC access and network services:
Command
Step 1
configure terminal
Step 2 aaa authorization network radius
OL-13018-01
Purpose
(Optional) Save your entries in the configuration file.
Enable RADIUS login authentication. See the
Login Authentication" section on page
Use RADIUS for privileged EXEC access authorization if authentication was performed by using
RADIUS.
Use the local database if authentication was not performed by using RADIUS.
Purpose
Enter global configuration mode.
Configure the switch for user RADIUS authorization for all
network-related service requests.
Controlling Switch Access with RADIUS
9-23.
Cisco IE 3000 Switch Software Configuration Guide
"Configuring RADIUS
9-27