Configuring Etherchannels - Cisco IE 3000 Software Configuration Manual

Configuring EtherChannels

Figure 33-3
Configuring EtherChannels
These sections contain this configuration information:
•
•
•
•
•
•
Note Make sure that the ports are correctly configured. For more information, see the
Configuration Guidelines" section on page
Note After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
to all the physical ports assigned to the port-channel interface, and configuration changes applied to the
physical port affect only the port where you apply the configuration.
Cisco IE 3000 Switch Software Configuration Guide
33-8
Load Distribution and Forwarding Methods
Switch with
source-based
forwarding enabled
EtherChannel
Cisco router
with destination-based
forwarding enabled
Default EtherChannel Configuration, page 33-9
EtherChannel Configuration Guidelines, page 33-9
Configuring Layer 2 EtherChannels, page 33-10
Configuring EtherChannel Load Balancing, page 33-12
Configuring the PAgP Learn Method and Priority, page 33-13
Configuring LACP Hot-Standby Ports, page 33-14
Chapter 33 Configuring EtherChannels and Link-State Tracking
(required)
(optional)
(optional)
(optional)
33-9.
"EtherChannel
OL-13018-01