Access Control Lists - Cisco IE 3000 Software Configuration Manual

Unsupported Commands in
Cisco IOS Release 12.2(44)EX
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the IE 3000 switch prompt but are not supported in this release, either because they
are not tested or because of IE 3000 switch hardware limitations. This is not a complete list. The
unsupported commands are listed by software feature and command mode.

Access Control Lists

Unsupported Privileged EXEC Commands
access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].
show access-lists rate-limit [destination]
show accounting
show ip accounting [checkpoint] [output-packets | access violations]
show ip cache [prefix-mask] [type number]
Unsupported Global Configuration Commands
access-list rate-limit acl-index {precedence | mask prec-mask}
access-list dynamic extended
Unsupported Route-Map Configuration Commands
match ip address prefix-list prefix-list-name [prefix-list-name...]
OL-13018-01
A P P E N D I X
Cisco IE 3000 Switch Software Configuration Guide
C
C-1