Pairing And Connecting A Bluetooth Headset - Polycom SpectraLink 8440 User Manual

Polycom SpectraLink 8400 Series Wireless Handset User Guide
• Headset
You can route audio to a headset by plugging a headset into the headset jack on the
right side of the handset. The headset jack accepts a four-conductor 2.5mm TRS plug. Note that
the headset jack will not function when the handset is docked in the Dual Charger (DCA39). See
Using the Dual Charger in Chapter 12.
• Bluetooth
If the system administrator enables Bluetooth capability, the Bluetooth option will
display in the Settings menu. You must pair and connect Bluetooth devices before you can hear
audio through the headset. See Pairing and Connecting a Bluetooth Headset in Chapter 2.

Pairing and Connecting a Bluetooth Headset

This section shows you how to pair and connect your Bluetooth headset.
Your 8400 series wireless handset has been tested for compatibility with Bluetooth v2.1
headsets. However, Polycom does not recommend using your headset while the 2.4 GHz
band is enabled. Bluetooth device behavior may also vary slightly between handset
models. The following instructions are intended as a guide, and may not specifically apply
to your Bluetooth device. You can usually find instructions on the manufacturer's Web
site.
To pair your Bluetooth headset with your handset:
1 Turn on the handset. Navigate to Settings > Basic Settings > Bluetooth Settings. The following
screen displays:
2 Select the Bluetooth On Off cell and turn Bluetooth on. When Bluetooth is turned on, the
Bluetooth icon (
3 Place the Bluetooth headset in discovery mode by holding down the answer/end button on the
headset.
8
) displays in the Status Bar.
May, 2011 | 1725-36720-001_RevA