Safety Instructions - Elumen8 ELUM021 User Manual

1. Safety Instructions
Please read the instructions carefully which includes important information
WARNING
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that
they also receive this instruction manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer
will not accept liability for any resulting defects or problems.
Unpack and check carefully that there is no transportation damage before using the unit.
—
The unit is for indoor use only. Use only in a dry location.
—
Only to be installed and operated by qualified operators.
—
DO NOT allow children to operate the fixture.
—
Use safety cables when hanging the unit. Handle the unit by its base only and not its head.
—
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent
—
surfaces.
Be sure that no ventilation slots are blocked, otherwise the unit will overheat.
—
Before operating, ensure that the voltage and frequency of power supply match the power
—
requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
—
Maximum ambient temperature TA: 40 . DO NOT operate when the temperature is higher.
—
DO NOT connect the unit to a dimmer pack.
—
Make sure there are no flammable materials close to the unit while operating to avoid a fire
—
hazard.
The unit's surface temperature may reach up to 85 . DO NOT touch the housing with bare-hands
—
during its operation, and allow 15 minutes for cooling before replacing the lamp or maintenance.
Avoid any inflammable liquids, water or metal objects entering the unit. If this occurs turn off the
—
mains power immediately.
DO NOT operate in dirty or dusty environment, clean the unit regularly.
—
DO NOT touch any cables during operation as there might be a hazard of electric shock.
—
C
about installation, usage and maintenance.
2C