Programming The Opener - Automatic Technology Axess Pro 1505 Installation Instructions Manual

6. Installation
Fig 6.5
top of door
12
15
Fig 6.6

7. Programming The Opener

The process for an automated program is as follows;
Program
Automated Full Logic
Set Up with Safety
Beams
When Safety Beams are not installed, the controller will display the following message;
ATTENTION! No Safety Beams have been detected. "Safety Close" mode has been turned on.
See Manual for details.
Press SET to continue.
NOTE: Fitting Safety Beams enables the Auto-Close feature to become active.
HELPFUL TIP: Install Safety Beams by following the Safety Beam Manual for wiring details to
tip
L2 Consoles.
10 Axess
®
12
11
120mm
max
13
6
14
Menu's required
Menu 10.1
Menu 1
Menu 6.1
Menu 3
Pro 1505 Installation Instructions
j. The door bracket comes in two parts. The door bracket
locator is placed over the door bracket
11
4 mounting holes for extra strength. Mount the door
bracket to the centre line of the door
or equivalent screws (not supplied).
NOTE: If in doubt about the strength of the door, reinforcement
may need to be added to the frame or panel where necessary.
Damage to the door panel may occur if the bracket is installed
incorrectly on a panel with insufficient strength. The door
opener warranty does not cover damage caused by the
opener to the door and/or door panel.
k. Assemble the bent
M8 x 25 Hex Head Screw
Flange Nut (Fig.
16
l. Connect the assembled arm to the door bracket
the trolley by a clevis pin
Trolley
16
15
5
Function Section
Setting the Limits 8.1 or 9.4
Coding the Transmitter 10.1
Safety Close Mode 13.1
Auto Close Times 13.2 to 13.5
12
(Fig. 6.5), using M6
and straight arm with two (2)
5 6
and two (2) M8 Hex Serration
14
6.6).
and a pin snap
15 13
NOTE:
The shuttle must be in
disengage position. Always use
both the bent & straight arms.
If installing on a door with bad
wave action, lengthening the
arm even further will assist the
door operation by reducing the
wave action.
and uses
and
12
.