To boot an OS via network, please make sure the following BIOS options In the
Advanced: Network Stack Configuration Menu are configured properly:
Network Stack
IPv4 PXE Support
Below are the steps to enable PXE boot.
1. It needs to set BIOS/ Advanced-> Network Stack Configuration-> Network Stack
as enabled (default setting is disabled)
2. When set Network Stack is enabled, and then go to item of " BIOS/ Advanced->
CSM Parameters -> Network" to enable PXE ROM function, set it as "Legacy" (IPV4
PXE) function .
_20161111
FWA-5020 User Manual v01
Enabled
Enables the UEFI Network Stack.
Enabled
Enabled if PXE booting in an IPv4 network;
Disabled
disabled otherwise
Table 2: PXE BIOS Options
Copyright 2015 Advantech Co. Ltd. All rights reserved.
Page 22