Safety Precautions - Static Electricity; Unpacking - Advantech FWA-5020 User Manual

15. The equipment does not work well, or you cannot get it to work according
16. The equipment has been dropped and damaged.
17. The equipment has obvious signs of breakage.
18. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE STORAGE
TEMPERATURE MAY GO BEYOND THE RANGE SPECIFIED IN
Specifications. THIS COULD DAMAGE THE EQUIPMENT. THE EQUIPMENT SHOULD
BE IN A CONTROLLED ENVIRONMENT.
19. CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY
THE MANUFACTURER, DISCARD USED BATTERIES ACCORDING TO THE
MANUFACTURER'S INSTRUCTIONS.
20. The sound pressure level at the operator's position according to IEC 704-1:1982 is no
more than 70 dB (A).
DISCLAIMER: The set of instructions is given according to IEC704-1. Advantech
disclaims all responsibility for the accuracy of any statements contained herein.

1.1.2 Safety Precautions - Static Electricity

Follow instructions below to protect yourself from harm and the products from
damage:
1. Be sure you are at an ESD workstation, or grounded with an ESD strap before opening
the top cover or installing/removing any unit accessible from the outside. Doing so will
discharge any static electricity that might have built up in your body.
Don't touch any components inside the system while the system is on.
2.
3. Disconnect power before making any configuration changes. The sudden rush of power
as you connect a jumper or install a card may damage sensitive electronic components.
4. When unpacking a static-sensitive component from its shipping carton, do not remove
the component's antistatic packing material until you are ready to install the component
in the unit.
5. When transporting any electrical component, first place it in an antistatic container or
packaging.
1.2

Unpacking

Please check the delivery for completeness as you open the carton carefully. If
any of the items listed in Table 1 is missing or damaged, please contact your
Advantech representative.
When opening the box, you will find the FWA-5020 embedded in protective foam and
the accessory box embedded to the foam. Remove the accessory box first and then
pull out the unit including the protective foam using both hands. Now, remove the
foam and the plastic sleeve on the unit.
After unpacking the unit, please check for any visible damage of the unit and contact
your Advantech representative in case of any issue.
Please note that unless agreed otherwise power cords need to be ordered
separately. Please refer to section 2.6 for ordering information.
_20161111
FWA-5020 User Manual v01 Copyright 2015 Advantech Co. Ltd. All rights reserved.
Technical
Page 14