Reinstalling The Top Cover; Disk Installation; Hdd Drive; Figure 45: Top Cover Flange Disengagement(Fwa-5020U-D0A1R) - Advantech FWA-5020 User Manual

Figure 45: Top Cover Flange Disengagement(FWA-5020U-D0A1R)

Now lift off and remove the top cover.

3.3.2 Reinstalling the top cover

You need:
-
a PH1/PH2 screw driver
To re-install the top cover slide it onto the unit from the top with the top cover flange
facing the unit's face plate. Keep a gap of about an inch between the front plate and
the flange.
After that, slide the top cover forward until the flange is fully seated underneath the
face plate.
Now insert the screws in the 7 locations shown above. Tighten each screw only
lightly then move on to the next screw. After all screws have been inserted, tighten
them.

3.3.3 Disk Installation

3.3.3.1 2.5" HDD drive

You need:
-
a PH2 screw driver
-
a standard 2.5" SATA HDD
-
the HDD carrier module (included in the unit)
-
the SATA cable (included in the unit)

Figure 46: Screws for HDD mounting

After removing the top cover, follow the instructions below for 2.5" disk installation:
1) Remove the HDD module from machine
2) The HDD carrier plate has two holes on each side to accommodate different
HDD vendor's mounting hole locations.
_20161111
FWA-5020 User Manual v01 Copyright 2015 Advantech Co. Ltd. All rights reserved. Page 78