Custom Scan Sizes Menu; Universal Setup Menu - Lexmark CX310 Series User Manual

Understanding the printer menus

Custom Scan Sizes menu

Use
Custom Scan Size [x]
Scan Size Name
Width
Height
Orientation
2 scans per side
Off
On

Universal Setup menu

Use
Units of Measure
Inches
Millimeters
Portrait Width
3–8.5 inches
76–216 mm
Portrait Height
3–14.17 inches
76–360 mm
Feed Direction
Short Edge
Long Edge
To
Specify a custom scan size name, size, and page orientation.
Notes:
•
8.5 inches is the U.S. factory default setting for Width. 216 mm is the
international factory default setting for Width.
•
14 inches is the U.S. factory default setting for Height. 356 mm is the
international factory default setting for Height.
•
Portrait is the factory default setting for Orientation.
•
Off is the factory default setting for 2 scans per side.
To
Identify the units of measure.
Notes:
•
Inches is the US factory default setting.
•
Millimeters is the international factory default setting.
Set the portrait width.
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
8.5 inches is the US factory default setting. You can increase
the width in 0.01‑inch increments.
•
216 mm is the international factory default setting. You can
increase the width in 1‑mm increments.
Set the portrait height.
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
14 inches is the US factory default setting. You can increase the
height in 0.01‑inch increments.
•
356 mm is the international factory default setting. You can
increase the height in 1‑mm increments.
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
83