4 ] Removing The Pcb Holder - Brother TD-2020 Service Manual

[ 4 ] Removing the PCB Holder

(1) Lift the release lever to open the roll cover ASSY, and remove the two taptite bind
B M2.6X8 screws. Close the roll cover ASSY and turn the machine upside down.
(2) Release each harness from the securing fixture.
(3) Remove the two taptite bind B M2.6X8 screws. Remove the PCB holder from the
machine, and pull out each harness from the two PCB holder holes.
Roll cover ASSY
Release lever
Taptite bind B
M2.6X8
Holes
Harnesses
Figure 3.4-6
III - 8
Taptite bind B M2.6X8
PCB holder