13 ]Attaching The Roll Cover Assy - Brother TD-2020 Service Manual

[ 13 ]Attaching the Roll Cover ASSY

(1) Insert each harness into the two holes of the machine, and set the roll cover
ASSY to the machine.
(2) Align the cut surface and set the damper shaft to the machine. Align edge A of the
damper spring to the groove of the machine, and set it to the damper shaft. Align
the cut surface to set the damper to the damper shaft, and attach the retaining ring
E2.5. Engage edge B of the damper spring with the damper groove.
NOTE: When assembling the damper, push the damper spring outward.
(3) Align the cut surface and set the damper shaft to the machine. Align edge C of the
damper spring 2 to the groove of the machine, and set it to the damper shaft. Align
the cut surface to set the damper to the damper shaft, and attach the retaining ring
E2.5. Engage edge D of the damper spring 2 with the damper groove.
NOTE: When assembling the damper, push the damper spring 2 outward.
Damper shaft
Damper spring 2
Retaining rings E2.5
Dampers
Damper spring
Edge D
Edge C
Damper spring 2
Harness
Damper
Figure 3.5-17
Damper shaft
Holes
Edge B
Damper
III - 42
Roll cover ASSY
Harness
Edge A
Damper spring