HP 5120 EI Series Lan Switching Configuration Manual page 228

Running Status
Join Timer
Leave Timer
Periodic Timer
LeaveAll Timer
Registration Type
Local VLANs :
1(default),
The output shows that:
Port GigabitEthernet 1/0/1 has learned VLAN 1 and dynamic VLAN 20 created on Device B
through MVRP.
Port GigabitEthernet1/0/2 has learned only VLAN 1 through MVRP.
Change the registration mode and verify the configuration:
2.
Set the MVRP registration mode to fixed on GigabitEthernet 1/0/3 of Device B, so that the
dynamic VLANs that Device B learns in VLAN 1 are not de-registered.
# Set the MVRP registration mode to fixed on GigabitEthernet 1/0/3.
[DeviceB] interface gigabitethernet 1/0/3
[DeviceB-GigabitEthernet1/0/3] mvrp registration fixed
[DeviceB-GigabitEthernet1/0/3] quit
# Display the local MVRP VLAN information on GigabitEthernet 1/0/3.
[DeviceB] display mvrp running-status interface gigabitethernet 1/0/3
-------[MVRP Global Info]-------
Global Status
Compliance-GVRP
----[GigabitEthernet1/0/3]----
Config Status
Running Status
Join Timer
Leave Timer
Periodic Timer
LeaveAll Timer
Registration Type
Local VLANs :
1(default), 10,
The output shows that the VLAN information on GigabitEthernet 1/0/3 is not changed after you
set the MVRP registration mode to fixed on GigabitEthernet 1/0/3.
# Delete VLAN 10 on Device A.
[DeviceA] undo vlan 10
# Display the local MVRP VLAN information on GigabitEthernet 1/0/3.
[DeviceB] display mvrp running-status interface gigabitethernet 1/0/3
-------[MVRP Global Info]-------
Global Status
Compliance-GVRP
----[GigabitEthernet1/0/3]----
: Enabled
: 20 (centiseconds)
: 60 (centiseconds)
: 100 (centiseconds)
: 1000 (centiseconds)
: Normal
: Enabled
: False
: Enabled
: Enabled
: 20 (centiseconds)
: 60 (centiseconds)
: 100 (centiseconds)
: 1000 (centiseconds)
: Fixed
: Enabled
: False
219