Mac Information Configuration Example; Network Requirements; Configuration Procedure - HP 5120 EI Series Lan Switching Configuration Manual

Step
2. Configure the MAC
Information queue length.

MAC Information configuration example

Network requirements

As shown in
address changes in Syslog messages to Host B through GigabitEthernet 1/0/3. Host B analyzes and
displays the Syslog messages.
Figure 9 Network diagram

Configuration procedure

Configure Device to send Syslog messages to Host B (see Network Management and Monitoring
1.
Configuration Guide).
Enable MAC Information:
2.
# Enable MAC Information on Device.
<Device> system-view
[Device] mac-address information enable
# Configure MAC Information mode as Syslog.
[Device] mac-address information mode syslog
# Enable MAC Information on GigabitEthernet 1/0/1.
[Device] interface gigabitethernet 1/0/1
[Device-GigabitEthernet1/0/1] mac-address information enable added
[Device-GigabitEthernet1/0/1] mac-address information enable deleted
[Device-GigabitEthernet1/0/1] quit
# Set the MAC Information queue length to 100.
[Device] mac-address information queue-length 100
# Set the interval for sending Syslog or trap messages to 20 seconds.
[Device] mac-address information interval 20
Command
mac-address information
queue-length value
Figure 9, enable MAC Information on GigabitEthernet 1/0/1 on Device to send MAC
33
Remarks
Optional
50 by default.