Step
3.
Enter Ethernet interface
view or port group view.
4.
Enable LLDP.
Setting the LLDP operating mode
LLDP can operate in one of the following modes.
TxRx mode—A port in this mode sends and receives LLDPDUs.
•
Tx mode—A port in this mode only sends LLDPDUs.
•
•
Rx mode—A port in this mode only receives LLDPDUs.
Disable mode—A port in this mode does not send or receive LLDPDUs.
•
To set the LLDP operating mode:
Step
1.
Enter system view.
2.
Enter Ethernet interface
view or port group view.
3.
Set the LLDP operating
mode.
Setting the LLDP re-initialization delay
When LLDP operating mode changes on a port, the port initializes the protocol state machines after a
certain delay. By adjusting the LLDP re-initialization delay, you can avoid frequent initializations caused
by frequent changes to the LLDP operating mode on a port.
To set the LLDP re-initialization delay for ports:
Step
1.
Enter system view.
2.
Set the LLDP re-initialization
delay.
Enabling LLDP polling
With LLDP polling enabled, a device periodically searches for local configuration changes. On detecting
a configuration change, the device sends LLDPDUs to inform neighboring devices of the change.
Command
•
Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
•
Enter port group view:
port-group manual port-group-name
lldp enable
Command
system-view
•
Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
•
Enter port group view:
port-group manual port-group-name
lldp admin-status { disable | rx | tx | txrx }
Command
system-view
lldp timer reinit-delay delay
193
Remarks
Use either command.
Optional.
By default, LLDP is enabled on
a port.
Remarks
N/A
Use either command.
Optional.
TxRx by default.
Remarks
N/A
Optional.
2 seconds by default.