Configuring Mrp Timers - HP 5120 EI Series Lan Switching Configuration Manual

Step
3. Configure the MVRP
registration mode.

Configuring MRP timers

CAUTION:
The MRP timers apply to all MRP applications, for example, MVRP, on a port. To avoid frequent VLAN
registrations and deregistrations, use the same MRP timers throughout the network.
Each port maintains its own Periodic, Join, and LeaveAll timers, and each attribute of a port maintains a
Leave timer.
To configure MRP timers:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the LeaveAll timer.
4. Configure the Join timer.
5. Configure the Leave timer.
6. Configure the Periodic timer.
Table 28 shows the value ranges for Join, Leave, and LeaveAll timers and their dependencies.
If you set a timer to a value beyond the allowed value range, your configuration will fail. To do that,
•
you can change the allowed value range by tuning the value of another related timer.
• To restore the default settings of the timers, restore the Join timer first, followed by the Leave and
LeaveAll timers.
Command
mvrp registration { fixed |
forbidden | normal }
Command
system-view
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
mrp timer leaveall timer-value
mrp timer join timer-value
mrp timer leave timer-value
mrp timer periodic timer-value
209
Remarks
Optional.
The default setting is normal
registration mode.
Remarks
N/A
Use one of the commands.
Optional.
The default setting is 1000
centiseconds.
Optional.
The default setting is 20
centiseconds.
Optional.
The default setting is 60
centiseconds.
Optional.
The default setting is 100
centiseconds.