HP 5120 EI Series Lan Switching Configuration Manual page 210

Port 2 [GigabitEthernet1/0/2]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors:
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV : 3
As the sample output shows, GigabitEthernet 1/0/1 of Switch A connects to an MED device, and
GigabitEthernet 1/0/2 of Switch A connects to a non-MED device. Both ports operate in Rx mode,
and they only receive LLDPDUs.
# Remove the link between Switch A and Switch B and then display the global LLDP status and port
LLDP status on Switch A.
[SwitchA] display lldp status
Global status of LLDP: Enable
The current number of LLDP neighbors: 1
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,5 minutes,20 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [GigabitEthernet1/0/1]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV
Port 2 [GigabitEthernet1/0/2]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors
: Enable
: Rx_Only
: No
: 0s
1
: 0
: 0
: 0
: 30s
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Rx_Only
: No
: 0s
: 1
: 1
: 0
: 0
: 5
: Enable
: Rx_Only
: No
: 0s
: 0
201