Configuring Lldp Trapping - HP 5120 EI Series Lan Switching Configuration Manual

Hide thumbs Also See for 5120 EI Series:
Table of Contents

Advertisement

CAUTION:
The maximum TTL value that CDP allows is 255 seconds. To make CDP-compatible LLDP work properly
with Cisco IP phones, be sure that the product of the TTL multiplier and the LLDPDU transmit interval is less
than 255 seconds.
CDP-compatible LLDP operates in one of the follows modes:
TxRx—CDP packets can be transmitted and received.
Disable—CDP packets cannot be transmitted or received.
To make CDP-compatible LLDP take effect on specific ports, first enable CDP-compatible LLDP globally,
and then configure CDP-compatible LLDP to operate in TxRx mode.
To enable LLDP to be compatible with CDP:
Step
1.
Enter system view.
2.
Enable CDP compatibility
globally.
3.
Enter Ethernet interface view
or port group view.
4.
Configure CDP-compatible
LLDP to operate in TxRx
mode.

Configuring LLDP trapping

LLDP trapping notifies the network management system (NMS) of events such as newly-detected
neighboring devices and link malfunctions.
LLDP traps are sent periodically, and the interval is configurable. To prevent excessive LLDP traps from
being sent when the topology is unstable, set a trap transmit interval for LLDP.
To configure LLDP trapping:
Step
1.
Enter system view.
2.
Enter Ethernet interface view or port
group view.
3.
Enable LLDP trapping.
4.
Return to system view.
5.
Set the LLDP trap transmit interval.
Command
system-view
lldp compliance cdp
Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
Enter port group view:
port-group manual port-group-name
lldp compliance admin-status cdp txrx
Command
system-view
Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
Enter port group view:
port-group manual port-group-name
lldp notification remote-change enable
quit
lldp timer notification-interval interval
198
Remarks
N/A
Disabled by default.
Use either command.
Disable mode by default.
Remarks
N/A
Use either command.
Disabled by default.
N/A
Optional.
5 seconds by default.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500 ei series5500 si series

Table of Contents