Call Settings; Caller Id; Call Waiting; Call Divert - TIPTEL Ergophone 6040 Operating Instructions Manual

Table of Contents

Settings

Call settings

This is where you set the network settings for calls.

Here you can specify whether your number is displayed to the person

you are calling on outgoing calls.

"Hide ID" means that your number is not displayed, while "Send ID"

means that it is sent. "Set by network" means that the network pro-

vider's setup determines whether your number will be displayed or

not. The usual default setting for network providers is that the number

is displayed.

This is where you can switch call waiting on and off, and query the

status set with the network provider.

If call waiting is switched on, any other call that comes in while you

are on the phone will be signalled by a call waiting tone, and you can

switch backwards and forwards between the two calls. The second

caller hears the ringtone. If you have switched off call waiting, the se-

cond caller hears the engaged tone if you are on the phone.

Here you can switch call diversion on and off, and query the current

status.

Select "All voice calls" if all your calls are to be diverted. With "Divert if

busy", other incoming calls are only diverted if you are on the phone.

"Divert if no answer" means that calls are diverted if you fail to take the

call within about 15 seconds. When you select "Divert if unreachable",

Table of Contents