Charging The Battery - TIPTEL Ergophone 6040 Operating Instructions Manual

Charging the battery

Your telephone is delivered with a charger and the corresponding
power supply unit. Insert the small connector on the power supply
unit into the jack at the rear of the charger, then connect the power
supply unit to the wall socket.
Put the telephone in the charger. The battery will now be charged.
The right-hand bar segment in the charge status display will flash on
and off in the display while it is charging. As soon as it is fully
charged, all the segments in the display will be filled in. The charge
status display will no longer be flashing.
Note: Instead of charging via the charger, the power supply plug
can also be connected directly to the jack on the under-
side of the telephone. The battery can also be charged via
a computer USB jack.
Before initial operation, completely charge the battery. To preserve
the battery, thereafter only place the telephone in the charger once
the battery is almost empty (when only 1-2 bars in the charge status
display are filled in).
Depending on the duration of your phone calls, you will usually need
to recharge the battery about once a week. Over time, battery per-
formance diminishes. If you notice after a time that you have to re-
charge you telephone more frequently, replace the battery.
Bringing into service
11