Switching On The Telephone - TIPTEL Ergophone 6040 Operating Instructions Manual

ing clip. The hollow in the casing must be in the same direction as the
SIM card. The SIM card must fit precisely into the hollow.
The battery is initially place on the top, on the contacts, with the hol-
low in the battery engaging with the guide on the casing. The battery
is then pressed down from above into the hollow in the telephone.
Then replace the casing cover and press it till it clicks into place.

Switching on the telephone

Press the hang up button
5 seconds until the display lights up.
The first time the telephone is switched on, you will be asked which
language you prefer. Select "English" here and then press the dial
key (with the green telephone receiver).
You will then be prompted (if it has been enabled) to enter your SIM
card PIN (personal identification number). You will find this four digit
number in the documentation for your SIM card. Use the keypad to
enter the four numbers, and then press the dial key
Bringing into service
(with the red telephone receiver) for 3–
9
Push the SIM card into the
SIM card bracket, as
shown. The SIM card is
pushed, with the card's
contacts underneath, be-
tween the telephone's con-
tacts and the metal retain-
The battery is then insert-
ed. The three contacts on
the battery must point to
the three contact pins on
the telephone on the top
left beneath the SOS but-
ton.
.