Table of Contents
Advertisement
After you have logged in the Web, the Web can automatically get a multiple cast address and add it to
the multiple cast groups. You can enable real-time monitor function to view the view.
Please note multiple cast function applies to special series only.
4.10.2.11 Register
This function allows the device to auto register to the proxy you specified. In this way, you can use the
client-end to access the DVR via the proxy. Here the proxy has a switch function. In the network service,
the device supports the server address format of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the auto
register function and the device can auto register to the proxy server.
1) The setup interface is shown as in Figure 4-68.
Important
Do not input a network default port such as the TCP port number.
Figure 4-68
2) The proxy server software is developed from the SDK. Please open the software and input the global
setup. Please make sure the auto connection port here is the same as the port you set in the previous
step.
3) Now you can add the device. Please do not input a default port number such as the TCP port in the
mapping port number. The device ID here shall be the same as the ID you input in Figure 4-68. Click the
Add button to complete the setup.
4) Now you can boot up the proxy server. When you see the network status is Y, it means your
registration is OK. You can view the proxy server when the device is online.
Important
The server IP address can also be a domain name, but you need to register a domain name before you
run the proxy device server.
75
Advertisement
Table of Contents
