Table of Contents
Advertisement
Start address/end address: You can input the IP address in the start address and end address. Now
you can click Add IP address or Add IP section to add.
a)
For the newly added IP address, it is in enable status by default. Click the delete icon to
remove the IP address.
b)
System max supports 64 items.
c)
The address column supports IPv4 or IPv6 format. If it is IPv6 address, the system can
optimize it. For example, system can optimize aa:0000: 00: 00aa: 00aa: 00aa: 00aa: 00aa as
aa:: aa: aa: aa: aa: aa: aa.
d)
The system automatically removes space if there is any space before or after the newly added
IP address.
e)
The system only checks start address if you add an IP address. The system checks the start
address and end address if you add an IP section. The end address should be larger than the
start address.
f)
The system may check if newly added IP address is valid or not. The system does not add if
input IP address does not exist.
Delete: Click it to remove specified item.
Edit: Click it to edit start address and end address. The system can check the IP address validity
after the edit operation and implement IPv6 optimization.
Default: Click it to restore default settings. In this case, the trusted sites and blocked sites are both
cleared.
Note:
If you enabled trusted sites, only the IP in the trusted sites list can access the device.
If you enabled blocked sites, the IP in the blocked sites can not access the device.
System supports adding MAC addresses.
Figure 4-59
68
Advertisement
Table of Contents
