In Figure 4-9, input the preset value and then click
the call.
Call Pattern
In Figure 4-9, input the pattern value and then click
the call.
Call Tour
In Figure 4-9, input the tour value and then click
Call Scan
In Figure 4-9, input the Scan value and then click
Rotate
In Figure 4-9, click
System supports preset, tour, pattern, scan, rotate, light, etc functions.
Note:
Preset, tour and pattern all need the value to be the control parameters . You can define it as you
require.
You need to refer to your camera user's manual for Aux definition. In some cases, it can be used for
special process.
Aux
Click
, and the system goes to the following interface. The options here are defined by the protocol.
The aux number is corresponding to the aux on-off button of the decoder. See Figure 4-13.
4.4.3 Color
to enable the camera to rotate.
Figure 4-13
to call a preset. Click
to call a pattern. Click
to call a tour. Click again
to call a scan. Click again
again to stop
again to stop
to stop the call.
to stop call.
36