Amcrest General 720P(V2) Mini 1U Series User Manual page 108

4.10.6.3 PTZ
The pan/tilt/zoom setup includes the following items. Please select the channel first. See Figure 4-83.

Control mode: You can select the control mode from the dropdown list. There are two options:
Serial/HDCVI. For HDCVI series products, please select HDCVI. The control signal is sent to the
PTZ via the coaxial cable. For serial mode, the control signal is sent to the PTZ via the RS485 port.

Protocol: Please select DH-SD1 if the control mode is HDCVI.

Address: Select the corresponding PTZ address.

Baud rate: Select the baud rate.

Data bit: Select the data bits.

Stop bit: Select the stop bit.

Parity: There are three choices: none/odd/even.
After completed all the settings please click save button and the system goes back to the previous menu.
Figure 4-822
99