Table of Contents
Advertisement
Parameter Function
Parity
5.8.5.4 ATM/POS
The ATM/POS function is for financial areas. It includes a Sniffer, an information analysis and title
overlay function. The Sniffer mode is network.
The network type interface is shown as below. See Figure 5-64.
Here we use the ATM/POS protocol to continue.
There are two types: with or without the protocol according to the client's requirements.
With the protocol
For ATM/POS with the protocol, you just need to set the source IP, destination IP (sometimes you need
to input corresponding port number).
Without the protocol
For the ATM/POS without the protocol, the interface is shown as in Figure 5-65.
The source IP refers to the host IP address that sends out information (usually it is the device host.)
The destination IP refers to other systems that receive information.
Usually you do not need to set a source port and target port.
There are total of four groups IP. The recording channel applies to one group (optional) only.
Six frame ID groups verification can guarantee information validity and legal.
Default setup is none. Please set according to the speed dome dial
switch setup.
Figure 5-64
147
Advertisement
Table of Contents
