Table of Contents
Advertisement
Please refer to the following sheet for detailed information.
Parameter Function
Event
Type
Enable
Delay
Show
message
Send
Email
Buzzer
5.8.4 Storage
5.8.4.1 Schedule
In this interface, you can add or remove the scheduled recording/snapshot setup. See Figure 5-52.
Figure 5-50
Figure 5-51
The abnormal events include: No disk, disk error, disk no space, net
disconnection, IP conflict, and MAC conflict.
You can set one or more items here.
Less than: You can set the minimum percentage value here (For disk
no space only). The device can alarm when the capacity is not
sufficient.
You need to check this box to enable this function.
Check the box here to enable selected function.
The alarm output can delay for the specified time after an alarm stops.
The value ranges from 1s to 300s.
The system can pop up a message to alarm you on the local host
screen if you have enabled this function.
If you enabled this function, the system can send out an email to alert
you when an alarm occurs.
Check the box here to enable this function. The buzzer beeps when an
alarm occurs.
138
Advertisement
Table of Contents
