Table of Contents
Advertisement
General information
Before operation please read these instructions to get an overview of how to
operate, maintain and service your Rinnai gas fire.
Care and maintenance
All external surfaces of the fire can be cleaned
using a soft damp cloth and mild detergent.
Do not use solvents and do not attempt to
clean the fire while it is hot or operating.
Electrical connection
The Ember is fitted with a 1.5 m power cord
and 3-pin plug. The power cord passes
through a slot in the back left hand corner of
the appliance.
The connection is either direct wired* or
connected to a power point within the cavity.
This must be connected to a dedicated
earthed power point. The electric isolation
switch must be accessible after the appliance
has been installed.
The fire must not be located immediately
below a socket outlet (potential fire hazard).
If the supply cord is damaged, it must be
replaced by a licensed tradesperson. This
must be a genuine replacement part available
from Rinnai.
Installation by a licensed tradesperson
Only a licensed tradesperson can install,
adjust, maintain, and service this gas fire.
Any work carried out by a non-licensed
tradesperson is illegal and will void any
warranty.
* Consult a qualified electrician if direct wiring is required as it must comply with AS/NZS 5601 and AS/NZS 3000 and other
relevant local regulations
Installer handover
Ensure your installer talks to you about the
use and care of this appliance, and that you
understand these instructions. The installer
also needs to complete the appliance
installation checklist and installer details, and
leave this guide with you.
Safety devices
Your Rinnai Ember has the following safety
devices; flame failure sensing system, pressure
relief, overheat safety switch, air temperature
sensor, thermal fuse, overcurrent fuse, and a
spark detector.
Soot deposits
Small soot deposits inside the heater or glass
is normal. Significant soot build-up however is
not normal and will require a service call. Refer
to the troubleshooting section for further
information.
Environmental
The Rinnai Ember is
manufactured from a number of
recyclable materials. At the end
of its useful life please consider
what parts could be recycled,
for example scrap metal.
Ember Operation Guide: 12889-A 01-17 | 9
Advertisement
Table of Contents
