Table of Contents
Advertisement
What's happening
Performance problems
Warm air not coming from heater when it starts
Fan continues to run after the heater is turned
off.
Fire will not light when switched on
Unit stops during operation
Remote problems
Remote control doesn't work
No display on remote.
Possible error codes* on remote when batteries are activated or changed:
F1 displays on remote
F2 displays on remote
* Unlikely to occur, but possible if there has been an assembly fault or failure with the remote.
Explanation and/or possible solution
The fan starts automatically after a short delay.
This is to allow the appliance to warm up,
helping avoid cold draughts.
This is to remove residual heat from within the
appliance. This stops once the unit cools down.
Ensure the power cord is plugged in and turned
on. Ensure gas supply is turned on.
Possible power failure, or gas supply may have
been turned off.
Unit not plugged in properly or has been turned
off—plug in power cord or press On/Off button.
Remote lock-up due to signal being out of
range, incorrectly aimed at unit or obstructed.
Batteries may be flat, change batteries.
Assembly fault, remote will not respond to
movement—accelerometer not communicating
with the main processor correctly. Contact
Rinnai.
Room temperature outside 5-45 °C, or
temperature sensing circuit has failed, which
may indicate an assembly fault. Contact Rinnai.
Ember Operation Guide: 12889-A 01-17 | 15
Advertisement
Table of Contents
