Driving Position Memory
The desired driving position can be called
up after programming the position.
The following driving positions can be
programmed.
Driver's seat position (seat slide, height
adjustment, front edge of seat bottom,
seat recline)
Refer to Seat Operation on page 2-5 .
Active driving display (display position,
brightness level, display information)
Refer to Active Driving Display on page
4-33 .
CAUTION
Do not place fi ngers or hands around
the bottom of the seat while the seat
memory function is operating. The
seat moves automatically while the
seat memory function is operating and
fi ngers or hands could get pinched and
injured.
SET button
The driving position can be programmed
or operated using the buttons on the side
of the seat or the key.
*
Programming
1. Make sure the parking brake is on.
2. (Automatic transaxle)
3. Start the engine.
4. Adjust the seat and the active driving
5. Press the SET button on the seat until a
6. Perform one of the following settings
NOTE
Lumbar support adjustment cannot
be programmed.
Individual seat positions can be
programmed to the two available
programming buttons on the side
of the driver's seat, plus one seat
position for each registered key.
If the vehicle has been serviced and
the battery leads disconnected, the
programmed seat positions will have
been erased. Re-programme the seat
positions.
Make sure the selector lever is in the P
position.
display to the desired driving position.
beep sound is heard one time.
within 5 seconds of completing step 5
above:
Programming using a button on
the side of the seat
Press the button you want to
programme, either button 1 or 2, until
a beep sound is heard one time.
Programming using the key
Press the key
sound is heard one time.
NOTE
If a beep sound is heard three times, the
operation is cancelled.
Essential Safety Equipment
Seats
button until a beep
2–7
*Some models.